|
Compressor Publications
|
Order #
|
|
Common Vibration Guidelines -
A listing of common vibration frequencies and their sources for rotating machinery on a nicely laminated desk side reference.
|
ML06-0134Rl
Mailed upon Request |
|
Design Optimization of a High Speed Motor Driven Centrifugal Compressor -
Design a centrifugal compressor to be used in a blower application...
|
SB07-0128Rc |
|
Impeller Failure Analysis -
MSI investigates a series of blade cracking problems in a compressor Impeller...
|
CS98-0104Rc |
|
Interference Diagrams:
When Campbell Diagrams Aren’t Enough -
...understand more about Interference Diagrams, how they are used...in assessing the potential for resonance problems in a centrifugal impeller or axial bladed disk...
|
T06-0137Rl
Mailed upon Request
|
|
Process Compressor Re-design -
FEA stress and vibration analysis was performed for three process compressor impellers installed in highly erosive service.
The objective of the analysis was to design a rerated impeller that would result in accurately predicted peak stresses that were at least a factor of safety of 2.0 below both the tensile yield strength...
|
SB00-0149Rc
Website only
|
|
Root Cause Analysis (RCA) –
Axial Compressor Example
|
CS08-0132Rc |
|
Rotor Instability Problems in an Integrally Geared Compressor -
MSI troubleshoots a newly commissioned critical compressor train experiencing unexplained vibration trips...
|
CS01-0116Rc |
|
Screw Compressor Noise and Vibration Elimination –
A Midwest coal-fired power plant was experiencing high vibration and noise in an
extensive screw compressor/ piping system required for pollution control...
|
SB00-0148Rc
Website only |
|
Shop Compressor Shaft and Casing Fatigue Study and Modification -
A new design of motor-driven shop compressor in France was needed to run reliably and quietly...
|
SB00-0147Rc
Website only |
|
Strain Measurement of a Centrifugal Compressor Impeller via FM Telemetry -
MSI worked closely with a major compressor OEM to specify, install and conduct strain gage testing of a centrifugal compressor impeller on the OEM test stand...
|
CS01-0117Rc |
|
Vibration Failures:
Dynamic Testing and Finite Element Modeling Have Been Successful Diagnostic Methods -
A well-practiced approach is needed to find solutions to failures due to vibration...
|
T08-0140RSl
Mailed upon Request |
